Willsenton R-35I EL34 x4 Tube Amplifier & Headphone Amp

Pure hand made, the whole machine uses point to point welding
Use high power Z11 iron core Japanese EI type power transformer specially designed for this machine
Use 12AX7 and 12AU7 vacuum tubes for voltage amplification and phase inversion, use EL34 vacuum tube for AB1 push pull power amplification; provide triode and super linear selection function
Peripheral power tube current adjustment button and current display header
Infrared function remote control
Boot mute delay function (about 30 seconds)
Japanese ALPS motor potentiometer
Easy to install plug in vacuum tube protection cover

Price : *

Technical Specifications

Rated output power:
20W (RMS triode working state)
35W(RMS super linear working condition)
Frequency response: 10HZ~40KHZ
Total Harmonic Distortion: 1% (1KHZ)
Signal to Noise Ratio: 90DB
Input sensitivity: 260MV
Input impedance: 100 KΩ
Output impedance: 4Ω, 8Ω
Headphone output impedance: 30Ω 300Ω
Power supply voltage: ~230V±5% (50HZ) ~115V±5% (60HZ)
Dimensions (WxDxH): (396 X 340 X 200) MM
Vacuum tube: EL34X4, 12AU7X2, 12AX7X2
Net weight: 18KG
Power consumption of the whole machine: 260W
Amplifier is NOT Bluetooth enabled

Tube amp must connected with speakers before turning ON. Strictly prohibit send signals to amp without connected loads(speakers) or load short circuit when the switch is ON.
Too high or too low power supply voltage does irreversible harm to the amp,preferably less than 5% of the specified voltage. If your mains voltage exceeds this value, often best to use with the AC power supply.
Temperature is higher when tube amps working, placing attention to ventilation, cooling.
In the boot or just shut down for a period of time (within 30 minutes) Do not spill liquid on the tubes.
You should take about 100h time to operate the amp.RUN-IN to the amp gives it’s best and stable sound.so during the first 100h use time the sound maybe is not the best,you can also use your own run-in method.
If you donot sure how to plug the tubes, please contact us before try it

Speakers connection:

All tube amplifier used with stereo mode: L(left) and R(right) speakers.

Normally there are 6 speaker cable connectors: +8L, +4L, -0L, -0R, +4R, +8R

Example: +8L and -0L are for connecting with your Left 6-8ohms speaker

-0R, +4R is for connecting with your Right 4ohms speaker